ETC Echo Expansion Bridge Installation Manual page 5

ETC Installation Guide
Expansion Bridge
Navigation Buttons
Buttons are provided to navigate the Expansion Bridge menu and edit
selected fields.
•
•
•
Reset Power
Using a ballpoint pen, press the [Reset] button to reset the Expansion
Bridge.
Menu
When the Expansion Bridge is connected to the EchoConnect bus, its
connection status displays as "E: " on the bottom of the display (for
each connected segment) when in the main menu.
About
The "About" menu provides read-only information regarding the
currently installed software on the Expansion Bridge. Pressing the
(enter) button navigates to the next screen, then returns to the main
menu.
Setup
IP Settings
Configure the network interface for the Expansion Bridge from the IP
Settings menu.
Automatic Mode
When Automatic IP mode is selected, all other IP address fields are
disabled. In "Automatic" IP mode, the Expansion Bridge will receive an IP
Address when its Ethernet interface is connected to a network with a
DHCP Server. A reboot is required after changing the IP address mode.
Manual Mode
When Manual IP mode is selected, the following settings are
configurable:
•
•
Expansion Bridge
(up) and (down) navigate the menu, or when a parameter
selection is made, press (or press and hold) to increase / decrease
the value
(back) navigates to the previous menu selection
(enter) commits a selection or edit
IP Address: by default, the address is 10.101.19.101
Subnet: by default, the subnet mask is 255.255.0.0.
Page 5 of 8 ETC