Table of Contents
Advertisement
ETC Installation Guide
Expansion Bridge
•
Use the
to set each octet of the selection. A reboot is required after changing the
IP address.
Logging Options
Send event messages to a logging server by enabling Syslog and
identifying the Syslog server IP address.
Syslog Enabled / Disabled
Select Syslog Enabled to send messages to the configured Syslog server.
Navigate to the Logging Options menu, the selected menu item will be
Syslog Enabled/Disabled.
Press the
until your desired setting is displayed. Press
Address or press the
Syslog Address
Configure the IP address to receive Syslog event messages. This defaults
to 10.101.50.60, the default IP address for ETC's Net3 Conductor.
Navigate to Syslog Address found in the Logging Options menu. The first
octet of the IP address is selected for edit.
Use the
selection. Press the
changing the Syslog IP Address.
File Operations
The File Operations menu provides access to restore the Expansion Bridge
to its factory defaults and update the device firmware.
Restore Defaults
To restore the Expansion Bridge to its factory defaults, returning the unit
to Automatic IP addressing mode, Use the navigation buttons to navigate
and select "Restore Defaults" from the menu. A message will prompt
confirmation of the Restore Defaults action. Select "Ok". The unit will
reboot.
Expansion Bridge
Gateway: by default, this is blank. A gateway address is only
required when the Expansion Bridge is used on a routed network.
In this case, this address should match the IP Address of the router
or gateway. When not used on a routed network, leave this setting
at its default.
button to select an option, and the
button to toggle the setting between Enabled and Disabled
button to exit the menu.
and
buttons to change the value, and press
button to exit the menu. A reboot is required after
and
to navigate to Syslog
Page 6 of 8
navigation buttons
to set the
ETC
Advertisement
Table of Contents
