Fiat Doblo Owner's Handbook Manual page 181

❒ operate the jack using the knob
(release the handle from the clip and
the hole on the nut) in order to open
it partially fig. 187, then position it
under the vehicle in line with
references A fig. 188 near the wheel
to be changed.
187
188
❒ operate the jack with the knob to
open it until the groove A fig. 189
of the jack is correctly inserted in the
lower profile B on the side member:
189
❒ warn anybody nearby that the vehicle
is about to be lifted. They must stay
clear and not touch the vehicle until it
is back on the ground.
❒ introduce the handle in the hole on
the nut and the plastic clip, then
F0V0154
operate the jack and raise the
vehicle, until the wheel is a few
centimetres off the ground. When
turning the crank, ensure that it
rotates freely in order to avoid grazing
your hands against the ground. The
moving components of the jack
(screws and joints) can also cause
injuries: avoid touching them. If
you become soiled with the
lubricating grease, clean it off
F0V0155
thoroughly;
❒ fully loosen the fixing bolts and
remove the wheel;
❒ make sure the contact surfaces
between spare wheel and hub are
clean so that the fastening bolts will
not come loose;
❒ fit the standard wheel by inserting the
first bolt B fig. 190 two threads into
the hole closest to the inflation valve
A;
F0V0156
190
❒ fit the hubcap, making sure that the
symbol aligns with the inflation
valve, and then insert the other three
bolts.
❒ tighten the bolts using the spanner
provided;
❒ turn the jack handle to lower the
vehicle, and remove the jack;
F0V0157
177