Thank you for purchasing the Robot Badge Kit.
This kit is part of a range of wearable badges designed
exclusively by Jaycar. Each project is powered by a
small CR2032 Lithium coin battery (Not included. We
recommend, SB2522), and the badges include a lapel
pin so you can wear it too.
Each of the designs has a different look and feel, while
the electronics involved is slightly different in each one,
so you'll learn more about electronics and how it works
even if you build them all!
Kit contents:
QTY
CAT. NUMBER PRODUCT
1
PH9238
CR2032 battery holder
RR0644
1
1MΩ resistors (Brown Black Black Yellow Brown)
RR0620
1
100K resistor (Brown Black Yellow Gold)
1
RR0572
1kΩ resistor (Brown Black Black Brown Brown)
1
RR0556
220Ω resistor (Red Red Brown Gold)
2
ZD0150
5mm LED RED
1
ZL3455
7555 Timer IC
PI6500
1
8 Pin IC Socket
RE6066
1
10µF Electrolyitc Capacitor
1
RC5496
0.1µF Monolythic Capacitor
1
AB3458
Buzzer
1
ZT2298
2N2222 Transistor
ADDITIONAL PARTS REQUIRED (Not included)
1
SB2522
CR2032 Battery
Disclaimer: Content can change without prior notice. Please visit the website page for the most up-to-date information.
learn to solder: Robot Badge Kit
learn to solder:
Badge Kit
WITH TOUCH ACTIVATED BUZZER & LED EYES
Before you start:
Open up the package and lay out the contents to ensure
you have them all based on the parts list. You should also
prepare a clean workspace and get all of the tools needed,
which we will discuss on the next page.
PCB MARKING
R3
R1
R4
R2
To fit 7555 IC
C1
Cat no.
KM1098
Robot
1