Bosch Rexroth 11 Series Instruction Manual page 22

22/60 Transport and storage
Transport with eye
bolt in drive shaft
(only permissible with
sizes 110 and 145)
Transport with eye bolt
in housing (only possible
for sizes 175, 210 and 280)
Bosch Rexroth AG, A15VSO/A15VLO Series 11, RE 92801-01-B/11.2018
Only use the lifting strap if you are unable to achieve the required installation
position with transport using the eye bolts.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶ For all female threads, use a stud end from the same system of units and
of the correct size.
▶ To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is indicated in the installation drawing.
▶ Make sure that the eye bolt can bear the total weight of the axial piston unit
plus 20%.
You can lift the axial piston unit as shown in Fig. 5 with the eye bolt screwed into the
drive shaft.
Fig. 5: Mounting the eye bolt in the drive shaft
▶ For all female threads, use a stud end from the same system of units and
of the correct size.
▶ Screw an eye bolt fully into the female thread in the housing.
▶ Make sure that each eye bolt can bear the total weight of the axial piston unit
plus approx. 20%.
You can hoist the axial piston unit as shown in Fig. 6 with the eye bolts screwed into
the housing.
Thread for eye bolt
Size 175: M10 x 1.75; 20 deep
Sizes 210 and 280: M12 x 1.75; 22 deep
Fig. 6: Mounting the eye bolt in the housing, top or bottom