Front And Rear Panel Components; Cabling Instructions; Cable Type - AMX DAS-T0804X-SIG Operation/Reference Manual

Installation

Front and Rear Panel Components

Power Switch & Receptacle
FIG. 1 Tango Amplifiers (DAS-TAMP4-SIG shown)

Cabling Instructions

This installation uses low voltage cabling similar to telephone and alarm wiring, and as such does not
commonly have very many restrictions on their installation. However rules may vary in different regions.
Be sure to check for any wiring restrictions required by the electrical code in your
area.

Cable Type

The Tango Amplifier is cabled using standard 4-conductor speaker cable originating at the Tango Controller,
passing through the Keypad, and terminating at the speaker location. AMX recommends using a bundled 4-
conductor 16-gauge stranded copper wire in a single continuous run.
4
Expansion Port IN: from Tango Audio Controller
Address Switch
Stereo Inputs/Outputs (8)
Paging IN/OUT
Zone Outputs (up to 8)
Expansion Port OUT:
or other Expander to other Expander
(rear)
Tango Zone Expanders