Global Settings - AMX CSG-500 Operation/Reference Manual

The options on the Operation Mode tab specify operational mode settings for your CSG which can vary
between countries. The following table lists the options on the Operation Mode tab of the Networking
Configuration page:
Networking Configuration - Operation Mode Tab Options
Option
Opermode
a-law Override
fxs Honor Mode
Boost Ringer
Low Power
Fast Ringer
Ring Detect
Tone Zone
Signalling

Global Settings

The Global Settings options enable you to view and edit your global settings configuration. You can use
the corresponding pages to manage your SIP or IAX configurations. FIG. 14 displays the SIP Global
Configuration page. You can access this page by selecting Global Settings | SIP from the System tab.
CSG SIP Communications Gateway
Description
This option enables you to select the country in which your CSG
is operating.
This option enables you to set the audio compression scheme.
The setting you choose is dependent on the country of operation.
U-law is used in the United States and Canada. A-law is used in
most other countries. If possible, confirm the scheme which is
best for operation of your CSG.
This option enables you to choose whether you apply the
opermode setting to your FXO modules only, or to both FXS and
FXO modules.
This option enables you to set the voltage used for ringing an
analog phone. You can choose from normal and peek(89V).
Normal sets the ring voltage to a normal level. Peek sets the
voltage to 89v.
This option enables you to set the low power to normal or to a fast
ringer peak of 50v.
This option enables you to set the fast ringer tone to normal or to
a 25Hz tone.
This option enables you to select the ring detect mode. Users
who are experiencing trouble detecting caller ID from analog
service providers or whose lines exhibit a polarity reversal before
the provider transmits caller ID should select Full Wave.
Otherwise, choose Standard.
This option enables you to select the touch tones, as defined by a
two-letter country code, which you will hear when pressing the
keys on your analog phone.
This option enables you to select the type of signalling. You can
choose from Kewl Start and Loop Start. Kewl Start is the default
setting.
Configuration
25