Use Environment - Zero Breeze MARK 2 Series User Manual

ACCESSORY CONNECTION Exhaust hose connection instructions
1

USE ENVIRONMENT

Your installation location should meet the following requirements:
•Make sure that you install your unit on an even surface to minimize noise and vibration.
•If using with a power adapter, the unit must be put near a grounded plug.
•When Mark 2 is working and the air duct is not connected, make sure that there is no obstruction in the exhaust air
inlet and outlet at least 100cm, and there is no obstruction in the front supply air and inlet at least 30cm.
•DO NOT cover the Intakes, Outlets or Remote Signal Receptor of the unit, as this could cause damage to the unit.
Electrical Safety
When using outdoors, pay attention to waterproofing, especially in rainy days. Keep the exhaust and air inlets clear and prevent foreign objects from
blocking or inhaling.
Tips:
1.Please leave Mark 2 flat for more than 30 minutes before turning on
when it is turned on for the first time, or after long distance or bumpy
transportation.
2.Please ensure Mark 2 is placed smoothly, not tilted, not upside down
when using it at any time.
09
3
*When using the Mark 2 in a large space or
outdoor open space, the Mark 2 is
equivalent to a cooler, without the need to
connect the exhaust hose.
*When using in a small confined space and
want to cool down the space, please
connect the exhaust hose and place it
properly.
＞30cm
PLACED IN A TENT
Conventional tent / tent with air conditioning interface
2
Suggestions：
•Pay attention to tent insulation. If the tent is poorly insulated, cover the tent with an insulated mat.
•Pay attention to the tightness of the tent. For tents with vents, close or cover the vents.
•Pay attention to shade the tent, it is recommended to use it in the shade.
•If it is a large tent, beyond the cooling range of Mark 2, please add one or more air conditioners, or create a small
cooling space with a cloth partition in the tent.
＞100cm
10