Zero Breeze MARK 2 Series User Manual page 5

Charging the battery through the power adapter
Battery Input Interface
Battery charging status indicator flashes
BATTERY charging state
LED1 LED2 LED3
*Zero Breeze will not be held responsible for any consequences caused by charging with chargers not provided by Zero Breeze.
*When the battery level indicators are all on, it means that the battery is fully charged.
*The batteries shown in this manual need to be purchased separately, please refer to the zerobreeze.com for more details.
07
Home AC
100~240V(50Hz/60Hz)
24V Power Adapter
Mark 2 Power Adapter
Home AC 100~240V(50Hz/60Hz)
LED4 LED5 Current power
0％-20％
20％-40％
40％-60％
60％-80％
Full
ACCESSORY CONNECTION Drain pipe connection instructions
1. Air condition needs to be equipped with drain pipe.
Connect the drain pipe to the drain and place the other end of the drain pipe into a container or drain area.
*Take care not to place the drain hose close to the power supply.
*Make sure that the hose is fastened and that there are no leaks and no kinks that impede the flow of water. Make sure that the end of the hose is
facing down to allow the water to flow smoothly.
2. The machine should be kept level when it is in use. It is best to lean it backward 5-10 degrees, not forward or left or
right, otherwise the condensate water will leak from the front, side and bottom of the air conditioner.
√
3. Do not move the air conditioner immediately after using the air conditioner. Tilt the air conditioner backwards slowly
by 30 degrees to ensure that the water in the air conditioner is drained.
Note: if there is leakage due to improper placement, there is no need to be nervous, just wipe it or cool it naturally, it will
not affect the performance of the machine.
√ ×
08