Table of Contents
Advertisement
GUIDE TO DISPLAY CODES 11
Pump Calibration Messages
This screen appears each time the meter enters pump or pH
calibration mode by pressing the CAL button. The meter is ready
to start pump calibration by pressing the PUMP button. The
meter returns to the main screen by pressing the CAL button.
This screen appears while pump calibration is in progress.
Pressing CAL or START STOP button, the minititrator returns
to the main screen.
This screen appears for a few seconds before returning to the
main screen, when pump calibration is done.
This error message appears when the sample concentration
exceeds 400 ppm.
The used standard solution is wrong.
This error message appears when the input readings (mV)
exceed the input limits (0÷1000mV).
Advertisement
Table of Contents
