Cabinet Installation - LG LW1517IVSM Owner's Manual

Cabinet Installation

Center Line
1
Open the window. Mark a line on the center
of the inside sill.
Carefully place the cabinet in the window and
align the center hole on the cabinet bottom
front with the center line on the sill.
Center Hole
2
Pull the bottom window sash down behind
the upper guide until It meets the cabinet.
NOTE
● Do not pull the window sash down so
tightly that the movement of the curtain
panels is restricted.
3
Inside Sill
Outside Sill
4
Inside Sill
Window Sash
5
Upper Panel
Guide
Loosely assemble each sill support.
Sill Support
Nut
Bolt
NOTE
● If the distance to the outer window sill is
not that deep, you may not need the bolt
and nut.
Use 2 type A screws to attach a sill support
to the cabinet track holes on one side. Use
the cabinet track holes that will place the sill
support nearest to the outer edge of the sill.
The longer side of the sill support should be
facing outside the window.
Repeat with the second sill support on the
opposite side of the cabinet.
Outdoor
Install the cabinet with a slight tilt (about 1/2"
(12.7mm)) downward on the outside.
Use the bolt and nut to adjust the tilt of the
cabinet.
CAUTION
● Do not drill a hole in the bottom pan.
The product is designed to operate with
approximately 1/2" (12.7mm) of water in the
bottom pan. There is no need to add water
if the pan is dry.
13 EN
INSTALLATION
Cabinet Track Holes
Screws (Type A)
Indoor
about 1/2"
(12.7mm)
Cabinet