Table of Contents
Advertisement
9. REPAIRING THE TOOL AND TROUBLESHOOTING
9.1 MAINTENANCE AND REPAIRS
All quality tools may require maintenance over
time or replacement of parts due to normal
operating wear.
These operations must be carried out ONLY by
an authorized technician.
NEVER TRY TO REPAIR THE TOOL YOURSELF.
9.2 TROUBLESHOOTING
WARNINGS:
Disconnect the air supply
from the tool before carrying out any
maintenance procedures.
PROBLEM
1 Air leak in the tool cover or trigger
area.
2 The tool does not operate or
operates slowly.
3 Air leakage in the bottom part of
the tool.
4 The tool jams frequently.
5 Other problems
CAUSES
Loose screws.
Worn or damaged o-rings or seals.
Inadequate air supply.
Insufficient lubrication.
Worn or damaged o-rings or seals.
Loose screws.
Worn or damaged o-rings or seals.
Unsuitable fasteners.
Damaged fasteners.
Loose magazine screws or front
screws.
Dirty magazine.
29
SOLUTIONS
Tighten the screws. Install a repair
kit.
Check the screws. Install a repair
kit.
Tighten the screws. Install a repair
kit.
Check that the fasteners are the
correct size. Replace worn or
damaged fasteners. Tighten the
screws. Clean the magazine.
Contact your local distributor for
service.
EN
Advertisement
Table of Contents
