Table of Contents
Advertisement
6. LUBRICATION
6.1 Disconnect the air supply from the tool
before lubricating it (1).
6.2 Add a few drops of tool oil to the air inlet.
Position the tool with the air inlet connector
facing upwards and place a drop of tool oil
inside the air inlet. Do not use cleaning oil or
additives. Put the tool into operation briefly
after adding the oil (2).
Wipe off any excess oil in the outlet. Excess oil
may damage the O-ring seals of the tool. If a
lubrication system is used, manual lubrication
through the air inlet will not be necessary on a
daily basis.
7. RELEASING THE JAMMED TOOL
7.1 Fasteners jammed in the expulsion area:
Disconnect the tool from the air tube.
Manually lift the safety device, grip the jammed
fasteners with pliers and remove them (1).
Fasteners jammed inside the magazine:
Disconnect the tool from the air tube.
Pull the magazine cover back.
If necessary, manually lift the safety device and
remove any jammed fasteners.
Push the magazine cover forward until it locks
into place.
1
OIL
2
1
27
EN
Advertisement
Table of Contents
