Tip; Warranty - NCE Switch-It Quick Manual

TIP:

If you use power routing turnouts such as Peco Electro-Frog, Shinohara or Walthers
we suggest wiring a #1156 automotive taillight bulb in series with the points of the
turnout (see above). This will prevent short circuits from shutting down your power
booster in the event you enter the turnout from the frog end without aligning the points.
Warning: This product contains chemicals known to the State of
California to cause cancer, birth defects or other reproductive harm.

Warranty

This decoder is fully factory tested and warranted against manufacturing defects for a
period of 1 year. As the circumstances under which this decoder is installed can not be
controlled, failure of the decoder due to installation problems can not be warranted. This
includes misuse, miswiring, operation under loads beyond the design range of the
decoder or short circuits in the locomotive manufacturer's factory wiring. The warranty is
voided if the decoder is miswired, connected to more than 22 volts, or used with switch
motors drawing more than 40mA.
If the decoder fails for non-warranted reasons NCE will replace the decoder, no questions
asked, for $10 US plus $2 shipping. For warranty or non-warranty replacement send the
decoder (an any payment, if required) to:
NCE Warranty Center
The terms Silent Running, Power Pro, PowerCab , ProCab, Switch-It, Snap-It, the NCE logo with "Power of DCC" slogan are
trademarks of NCE Corporation. Digitrax is a trademark of Digitrax Inc. Tortoise is a trademark of Circuitron, Inc. MRC is a
trademark of MRC Corporation. The distinctive shape of the ProCab when used with a thumbwheel speed control and LCD
display is a trademark of NCE Corporation.
Last revised: 15 March 2007
Tortoise
Machine
Shown
#1156
Bulb
899 Ridge Road
05240114
05240114
Webster, New York 14580
Page6