Advertisement
13.
Once fully lowered, latch pins on both sides
and rotate panel to TRAVEL MODE.
7.
Install the support plates for transport.
ALWAYS connect support plates prior
to transporting the trailer! Pull the panel
array toward the plate and slide the
support plate down to lock into place.
Repeat this process for both panel arrays!
8.
Extend the trailer hitch jack located at the front of the trailer.
9.
Retract the remaining (4) jacks located
on the front and back of the trailer by
rotating the hand crank counter-
clockwise. Pull the pin and rotate each
jack 90° upward, horizontal with the
trailer.
10.
Connect the trailer hitch to your tow vehicle. Ensure the safety chains
and cable have been connected! Make sure everything is properly
latched and secure before towing.
The unit is ready for transport.
SPLT-1.59K-800A-30-4X100W-LED-MS
NOTES:
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
____________________________________________________________
Larson Electronics LLC
9419 US-HWY 175
Kemp, TX 75143 USA
P: 800-369-6671 | INTL: 903-498-3363 F: 903-498-3364
sales@larsonelectronics.com
www.larsonelectronics.com
ver.0118-1
5
Advertisement
