Porsche Connect Driver Manual page 25

The vehicle doors and the tailgate are unlocked or
locked. The alarm system is activated and the lock
symbol is displayed when locking.
Using alarm functions
To use the full range of functions, the following re-
quirements must be met:
b b Private mode is deactivated.
b b Remote access authorisation granted in the
PCM.
> Please refer to chapter "Installing & using" on
page 3.
Car Alarm
If the vehicle alarm system is triggered, a Push noti-
fication with information on the type and time of the
alarm is sent directly to the mobile phone.
Location, speed and valet alarm
1. Select My Car in the app main area.
2. Move down by swiping vertically (Alarms and
Modes).
3. Select Change settings.
4. Select the alarm you want
– Location: A geographical area can be defined. If
the vehicle enters or leaves this area, an alarm
message is sent.
– Speed: A limit speed is specified. If this limit
speed is exceeded, an alarm message is sent.
– Valet: A preconfigured combination of location
and speed alarm can be activated. An alarm
message is sent when a parameter is exceeded.
Geographical areas and limit speeds can be added
and activated via the Add alarm function.
Stored geographical areas and speed limits can be
edited or deleted via the Edit function.
Information
Changes to limit settings affect all app users that
access the same vehicle.
Setting precool/heat functions
Precooling/heating of the vehicle can be operated
remotely via the app. Depending on the equipment,
advanced settings can be made, e.g. the seat heating
can be activated.
The availability of the function depends on the ve-
hicle type and configuration. Further information is
available from your Porsche partner.
To use the full range of functions in the app, the fol-
lowing requirements must be met:
b b Private mode is deactivated.
b b Remote access authorisation granted in the
PCM.
> Please refer to chapter "Installing & using" on
page 3.
b b Battery is sufficiently charged (<10 %).
Immediate start
Precool/heat can be activated and deactivated
immediately.
The desired temperature can be specified.
1. Select My Car e Air conditioning in the app's
main area.
2. Select Start.
Precool/heat is immediately switched on and
adopts the standard temperature set in the app.
Precool/heat stops after 60 minutes.
Porsche Connect App
Information
– Air flow and air distribution are regulated auto-
matically, irrespective of which settings were
active when the vehicle was parked.
– The precool/heat function in your vehicle is only
activated when the high-voltage battery is suffi-
ciently charged. For further information on the
high-voltage battery charging process, please
refer to the separate Driver's Manual.
– Please note that the charge status of the high-
voltage battery can be reduced or the charging
process delayed by precooling/heating.
Seat heating/seat ventilation
Seat heating/seat ventilation can be started and
stopped immediately.
e Select My Car e Air conditioning in the app's
main area. Seat heating/seat ventilation can be
switched on or off by tapping the relevant
buttons.
Seat heating/seat ventilation is started imme-
diately and adopts the last temperature set in
the vehicle.
Information
The timer uses the time set in the vehicle not the
time set on the mobile phone.
Using E-Control
Using the app, you can remotely control the charging
process for your vehicle and display the current
status.
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
23