Table of Contents
Advertisement
Footnote
*0) xx=data-1, yy=data-2. Default: data-1=00, data-2=E0
*1) The slow-motion speed range is 0±3 times PLAY speed.
*2) The low-resolution speed data consists of one byte (Value=0-255).
The real speed in multiplies of play is defined as:
Real speed=10
This means the speed data is the logarithmic of the Real speed.
0.1xplay, Value=64: 1xplay, Value=96: 10xplay)
*3) 0±3 times PLAY speed is executed as VARIABLE. More than this speed is executed as
SHUTTLE to allow synchronization of the machine with this command. (0±40 times PLAY)
*4) The high-resolution speed data consists of two bytes, but only the first data byte is used to
calculate the tape speed (refer to the foot note *2).
*5) The parking accuracy is 0 frame.
*6) The time code data consists of four bytes coded BCD (Binary coded decimal).
・ Data 1=Frames
・ Data 2=Seconds
・ Data 3=Minutes
・ Data 4=Hours
*８) The time base for this operation can be set with the TAPE CODE SELECT command.
*9) This operation is done with the selected tracks and the record mode of the EDIT PRESET
command.
*10) The IN point and the OUT point must be set before, with IN/OUT ENTRY command or
IN/OUT DATA PRESET command.
*11) If the servo is not locked, this command is executed as a FULL EE ON to allow to do BVB
（Black-VIDEO-Black） simulation.
*12) The user bit data consists of four bytes (high nibble, low nibble
・ data-1: binary group 2 / binary group 1
・ data-2: binary group 4 / binary group 3
・ data-3: binary group 6 / binary group 5
・ data-4: binary group 8 / binary group 7
（
）
Value/32-2
52
(e.g. Value=32:
Advertisement
Table of Contents
