Table of Contents
Advertisement
3-3. Clip Edit
3-3-1. Making clips from playback file
You can edit and make clips by designating the IN point and OUT point from the playback
material file on the Material list. Also, you can change the IN point and OUT point of already
determined clips.
How to set clips
(1) Select the [Single file mode] on the [Playback Settings] menu (or push the [F1] key).
(2) Select the file on the Material list by double click. If you want to change the
pre-determined clip, select that clip on the Clip list.
(3) By using the slide bar or other Deck control buttons, pause at the scene that you want to
set as the IN point.
(4) Click the [P Mark In] button ⑦ to take the timecode value for the IN point. You can also
directly type the timecode value in the IN point timecode box ②.
(5) As the same manner, pause at the scene that you want to set as the OUT point.
(6) Click the [P Mark Out] button ⑨ to take the timecode value for the OUT point. You can
also directly type the timecode value in the OUT point timecode box ④. If the Time code
value of the OUT point is smaller than the IN point value, the character color becomes
red and the clip edit is prohibited.
(7) By clicking the [Goto In] button ③, or the [Goto Out] button ⑤, you can cue-up to the
IN point or the OUT point respectively.
(8) By clicking the [Prev] button, you can preview the clip (playback from the IN point to the
OUT point). When the [Repeat] is set on the [Playback settings] menu, the playback
repeats from IN point and OUT point.
(9) When you want to change the IN or the OUT point, retry (3) to (6) above.
(10) If the IN point and the OUT point is OK, put the clip name in the [Name] box then click
the [Add] or the [Set] button. The clip is registered on the Clip list.
②
⑥
①
③
④
⑦
⑨
⑧
32
⑤
⑩
⑪
⑫
Advertisement
Table of Contents
