Step 11 Install Hard Disk - American Megatrends Titan II User Manual

Step 11 Install Hard Disk

Attach IDE Cable to P3
P3 is the primary IDE (Integrated Drive Electronics) hard disk drive connector. Both the primary master and the
primary slave IDE drives must be connected by cable to P3, as shown below.
P3 IDE Hard Disk Connector
P3 is a 40-pin dual-inline berg that connects a hard disk drive that has an IDE interface to the primary onboard IDE
Controller. This motherboard supports IDE Modes 0, 1, 2, and 3, prefetch, LBA (Logical Block Address) mode,
high capacity drives (over 528 MB), 32-bit data transfer, and fast IDE transfer. These IDE features are configured in
Peripheral Setup in the WINBIOS Setup utility.
Disable the onboard IDE interface in Peripheral Setup to use an ISA ESDI, RLL, MFM, or SCSI hard disk drive
controller.
P8 Secondary IDE Controller
P8, the secondary IDE connector, is a 40-pin dual-inline berg that connects the secondary master and slave IDE
drives to the secondary onboard IDE controller. Attach the secondary master and slave IDE drives to P8 via a
standard 40-pin IDE cable as shown on page 27. Disable the onboard IDE interface in Peripheral Setup to use an
ISA ESDI, RLL, MFM, or SCSI hard disk drive controller.
Titan-II PCI Pentium EISA Motherboard User's Guide
27