Table of Contents
Advertisement
Maintenance
Before carrying out any maintenance work on the compressor, make sure that
the main switch is set to "off,"
the pressure switch or the power button is set to "off,"
the air reservoir is completely pressure-less.
Condensed water
Remove the condensation water from the compressed air tank daily. To do this, release the pressure
from the compressed air tank, open the drainage valve on the underside of the compressed air tank
and drain the condensation water.
Safety valve
The safety valve factory settings is the maximum permissible pressure of the compressed air tank. It is
not permitted to remove the seal or adjust the safety valve.
Clean suction filter
The suction filter prevents dirt and dust from being sucked in. A dirty suction filter considerably re-
duces the performance of your compressor. It is therefore necessary to clean the filter every 300 oper-
ating hours. Hold the suction filter with your entire hand and carefully pull it out of its holder. Remove
the internal filter and wash it out with petrol. Allow the filter to dry completely before insertion. Place
the filter back in the housing and apply light pressure.
Attention: Risk of burns! Please wait until the compressor has cooled down completely.
Oil
Empty the oil in the crankcase after the first ten hours of operation and top up with clean oil.
•
Remove the oil plug from the crankcase (bottom left of crankcase).
Caution: SAE 30 or L-DAB 100 above 10°C and SAE 10 or L-DAB 68 below 10°C
•
Drain the oil every 500 operating hours and refill the crankcase with clean oil.
•
Disturbances
The following causes can lead to an overload of the compressor and thus to the response of the over-
load protection:
Insufficient air supply
•
Leaking check valve
•
Defective compressor valves
•
Heavy conrod bearing
•
Mains voltage too high
•
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61957
Page 8
12 2020-1
Advertisement
Table of Contents
