Table of Contents
Advertisement
Assembly of wheels and air filters
Mount the two included wheels according to the illustration (exploded view).
•
Mount the air filter (e).
•
Fill in oil
Operation without oil will cause irreparable damage to the unit
and void any warranty claims.
Remove the plastic oil inlet screw (b) from the top of the
•
compressor housing crankcase.
Pour the oil into the crankcase (c) until the oil level in the
•
sight glass (d) reaches the centre of the red circle.
Replace the oil inlet screw (a) and tighten firmly.
•
Technical data
Power supply
Engine power (W/HP)
Idle speed (rpm)
Suction capacity (ℓ/min)
Max. pressure (bar)
Tank (ℓ)
Weight (kg)
Grounding instructions
This compressor must be grounded during operation to protect the user from electric shock.
•
The single-phase compressor is equipped with a two-wire cable with earthing conductor.
It is recommended never to disassemble the compressor or make other connections to the
•
pressure switch. All repairs may only be carried out by a qualified technician. It must never be
forgotten that the earth conductor is "yellow/ green."
Extension
Only use extension cords with plugs and ground terminals, never use a damaged or crushed
•
extension cord. Before using them, make sure that the extension is in perfect condition. When
using an extension cord, also ensure that the cross-section is sufficient for the power con-
sumption of the connected product. A thin extension may result in a drop in voltage, loss of
power and excessive heat generation.
The single-phase compressor extension cable should have a cross-section appropriate to the
•
length of the cable.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
230 V ~ 50 Hz
1500 / 2
2850
206
8
24
24
Item 61957
Page 6
12 2020-1
Advertisement
Table of Contents
