WilTec 24 L Operation Manual page 3

Introduction
Thank you for purchasing this quality product. To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Important information
Please read the instruction manual thoroughly and understand it before putting the
•
device into operation. Improper use may result in damage or injury to people. People
who are not familiar with the manual may not operate the device.
Keep the instructions for use. Children and adolescents are not permitted to use the
•
device.
The majority of accidents during use of the compressor are due to non-compliance with basic
•
safety regulations. In order to avoid accidents, all potential sources of danger should be identi-
fied in good time and the relevant safety regulations should be complied with.
Never use the compressor improperly, but only as recommended by the manufacturer, and
•
only if you are absolutely sure that there is no danger to the user or people within the vicinity.
Note: Check the device before each use. If damage is found, do not continue to use the
•
device. Repairs must only be carried out by a qualified technician. Never open the device.
Safety
Read all instructions!
Use lines and air tools suitable for higher or equal pressure to the operating pressure of the
•
compressor.
Drain the condensation water from the boiler daily or every 4 operating hours. Open the ap -
•
propriate device and tilt the compressor to drain the accumulated water.
To avoid danger, the compressed air jet must never be directed at people or animals.
•
To avoid combustion, never touch the pipes, engine or any other hot components of the com -
•
pressor.
Do not make any changes to the compressor. Contact a qualified technician for all repairs. Un-
•
authorised modifications may affect the compressor performance or cause serious accidents if
performed by people who do not have the necessary technical knowledge.
Solvents such as petrol, thinner, diesel oil or other substances containing alcohol can damage
•
the plastic parts. These parts should not be cleaned with such substances but with soapy wa-
ter or suitable liquids.
If the compressor produces strange noises or strong vibrations during operation or if it is de-
•
fective, the compressor must be stopped immediately. Contact a qualified technician for
troubleshooting.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61957 Page 3
12 2020-1