Troubleshooting; Specifi Cations - Panasonic EH-NA98 Operating Instructions Manual

Troubleshooting

Problem
Sparks can be seen inside the appliance when
using [HOT].
(These sparks are caused by the thermostat switch
which is the protective device, and are not dangerous.)
Hot air repeatedly turns into cold air.
The hot air is abnormally hot.
The power plug is abnormally hot.
Sparks are generated inside the nanoe™ outlet.
A noise (crackling) is heard inside the nanoe™ outlet.
There is a peculiar smell.
Water droplets fl y out from the nanoe™ outlet.
The [HOT] lamp is blinking quickly (twice per
second).
If the problems still cannot be solved, contact the store where you purchased the unit or a service center authorised by Panasonic for repair.
Specifi cations
Product model
Power source
Power consumption
Accessory
Airborne Acoustical Noise
This product is intended for household use only.
18
EH-NA98_EU.indb 18 EH-NA98_EU.indb 18
Possible cause
Dust is attached to the air inlet or air
outlet.
Hair or something is blocking the air
inlet.
The power plug is not fi rmly inserted
into the outlet.
The needle-shaped part located at
the back of the nanoe™ outlet is dirty.
This is because nanoe™ and mineral ion produce a peculiar smell; there
is no infl uence to your body.
Water droplets occasionally fl y out from when generating nanoe™; this is
not an abnormality.
Device abnormality.
220 V 50 - 60 Hz
1 500 W
without nozzle 76 (dB(A) re 1 pW)
Remove the attached dust.
(See page 16 - 17.)
Do not block the air inlet.
Use an outlet in which the power
plug fi ts snugly.
Perform maintenance on the
nanoe™ outlet. (See page 17.)
Please consult an authorized
service center for repair.
EH-NA98
230 V 50 - 60 Hz
1 650 W
Set nozzle
Action
240 V 50 - 60 Hz
1 800 W
15/8/2562 15:01:02 15/8/2562 15:01:02