AquaScape AQUABLOX 29491 Instructions & Maintenance page 5

STEP 2
EXCAVATE LOCATION OF PONDLESS
Excavate a recessed area for the Pondless
the storage basin allowing maximum water availability for the pump system.
For Aquascape Rainwater Harvesting System kits, please refer to diagram section for Snorkel
locations.
Pondless Waterfall Vault
®
NOTE: An additional 6" of excavation is recommended per side.
Pondless Waterfall Vault location
®
when using 3 AquaBlox
Snorkel Vault and Centipede
®
STEP 3
PREPARE BASE
The base of the excavation should be smooth soil, flat and free of lumps and
debris. Check the size and depth of the excavation by placing the AquaBlox
the excavated area. There should be approximately 6" between the AquaBlox
the soil. Add compactable material such as sand, if existing soil conditions do not
meet requirements listed above. The compactable material should be spread to a 4"
minimum depth and compacted.
☎
aquascapeinc.com | CAN (866) 766-3426 |
WATERFALL VAULT, SNORKEL VAULT, AND CENTIPEDE MODULES
®
Waterfall Vault and Snorkel Vault. This positions the vault at the lowest point in
®
®
®
☎
US (866) 877-6637
Vault and Centipede
®
For maximum structural strength
on larger storage basins locate
Pondless Waterfall Vault
®
between AquaBlox
into
®
and
®
Module
®
®
5