Maintenance - SATA SATAjet 5000 B RP Operating Instructions Manual

Operating instructions SATAjet 5000 B RP/HVLP
• Check spray pattern after cleaning the nozzle set!
• Further tips concerning cleaning can be found at www.sata.com/TV.
9.

Maintenance

• Prior to maintenance, disconnect the spray gun from the compressed
air circuit!
• Disassemble and install components very carefully! Exclusively use
included special tools!
9.1. Replacing the nozzle set
and [7-6]
Every SATA nozzle set consists of "paint needle" [7-1], "air cap" [7-2]
and "fluid tip" [7-3] and has been hand-adjusted to provide a perfect
spray pattern. Lubricate both paint needle [7-1] in the paint needle area
(approx. 3 cm in front of the needle sleeve, paint needle spring) and ma-
terial flow control screw [1-11]. Therefore, always exchange the complete
nozzle set. After installation, please adjust material flow according to
chapter 7.2.
9.2. Replacing the air distribution ring
2], [7-3], [8-1], [8-2] [8-3], [7-4], [7-5] und [7-6]
• Remove the air distribution insert with the SATA extraction tool only.
• Do not apply force to avoid damage of sealing surfaces.
Notice!
Warning! Attention!
Attention!
[7-1], [7-2], [7-3], [7-4], [7-5]
Steps: [7-1], [7-
EN
107