Toto SW3056AT40 Instruction Manual page 7

Operational Precautions
■ Body Sensor Compliance
●FEDERAL COMMUNICATIONS COMMISSION
(FCC) INTERFERENCE STATEMENT
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
CAUTION:
Any changes or modi cations not expressly approved by
the grantee of this device could void the user's authority to
operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
RF exposure warning
This equipment complies with FCC RF exposure limits set
forth for an uncontrolled environment.
This equipment must not be co-located or operating in
conjunction with any other antenna or transmitter.
12
(Continued)
●Canada, Industry Canada (IC) Notices
This device complies with Industry Canada's licence-
exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below
the Industry Canada (IC) radio frequency exposure limits.
The Wireless Device should be used in such a manner
such that the potential for human contact during normal
operation is minimized.
This device has also been evaluated and shown compliant
with the IC RF Exposure limits under portable exposure
conditions.
(antennas are less than 8 inch (20 cm) of a person's
body).
13