Table of Contents
Advertisement
LEGIC Boosters | installation guide
3 Configuration
The LEGIC Booster is configured by means of configuration cards. This configuration card is a LEGIC Advant
transponder that contains all the information that is required to find the user's segment and read the data. The LEGIC
Booster only accepts a configuration card after configuration is enabled with a master token card.
A newly purchased LEGIC Booster will accept any master token card. Once a master token has been inserted, the
LEGIC Booster will only accept that specific master token and cannot be reconfigured with other master tokens.
3.1 Configuration card set
The configuration card set contains 3 cards that have the exact same stamp.
The master token IAM n/31 enables the programmer to write the configuration card.
•
The master token SAM n/31 enables the LEGIC Booster to accept the configuration card.
•
The configuration card.
•
Note: Previously the set contained only 2 cards (no SAM n/31 card included).
The IAM n/31 card was accepted on the LEGIC Booster as well as on the programmer
A special master token SAM n/32 can be used to perform a 'master token withdraw'. This will release the bonded
master token information and enables the Booster to accept any master token again (just like a virgin LEGIC Booster
from the factory). The 'withdraw' master token should have the exact same stamp as the original master token. The
SAM n/32 card is not included in the master token set.
3.2 Configuration procedure
Follow the procedure below to configure the LEGIC Booster for your application.
1.
Insert the master token SAM card in the LEGIC Booster and push the button.
The LEGIC Booster sounds the buzzer with an increasing frequency: ♪ ♪ ♪
The LEGIC Booster will now accept your configuration data card.
2.
Insert the configuration data card in the LEGIC Booster and push the button.
The LEGIC Booster sounds the buzzer with a decreasing frequency ♪ ♪ ♪
The configuration is accepted.
Now your LEGIC Booster will read the LEGIC smart cards that meet the conditions defined in your configuration.
7/18
Advertisement
Table of Contents
