Table of Contents
Advertisement
LEGIC Boosters | installation guide
3.3.2 Example configuration
In this chapter will be explained how to setup the configuration to accept LEGIC transponders with a Kaba Group
Header segment.
Operating Mode
Operating mode
Extended Driver-ID length
RFID Options
Enable ISO15693
Enable ISO14443A
Enable LEGIC prime
Enable Inside Contactless
Enable FeliCa
Enable ISO14443B
Search Definition
Search enable
Segment number
Segment type
Segment stamp search
Stamp length
Data Definition
Allocation of data to search definition
Data type
Data address
Data length
3.3.3 Booster config files
Your configuration can be saved into a Booster Config File (*.bcf). These files contain all the configuration settings as
you have defined them. Saved Booster Config Files can be easily opened from within the File menu.
Dual-ID
no
yes
no
yes
no
no
no
With segment search
1
Data segment
02
4
1
Segment data
0
3
Vehicle-ID and driver-ID.
not used
LEGIC Advant enabled
not used
LEGIC prime enabled
not used
not used
not used
Search for a segment.
Start searching at segment 1.
Segment must be a data segment.
Segment stamp should start with 02.
KGH defines a stamp length of 4 bytes.
Allocate data to search definition 1.
Read data from the searched segment.
Start reading at first byte after the stamp.
Read 3 bytes.
11/18
Advertisement
Table of Contents
