Table of Contents
Advertisement
LEGIC Boosters | installation guide
3.4 Testing the configuration
The configuration can be tested on your read/write unit with the LEGIC cards that should be supported. This test can be
performed before the configuration cards are created and without any LEGIC Boosters.
3.4.1 Start testing
Start reading by clicking 'Configuration', 'Test' and 'Start Reading' (or press F9).
When a transponder is found that meets the configured search definitions a message appears with the data that was
read.
Note for programmers based upon SC-2560 chipset:
The test configuration is first transmitted to the programmer. This will be written to the programmer's RAM IDB
settings. Next the software will send the AUTOREAD command.
Figure 4: Read data information message
Click 'Again' to repeat the test or 'Done' to stop.
When no transponder is found, you can abort reading by clicking 'Stop Reading' in the 'Configuration', 'Test' menu (or
press Shift + F9).
12/18
Advertisement
Table of Contents
