Operation Hours Switchover; Temperature Stage Function - Toshiba TCB-ACREDU1-E Manual

8.7

Operation hours switchover

In this image, the operating hours of the two indoor units are displayed and with the Function On / O
the hours of operation change-over is activated / deactivated. The switching time and the time
remaining until the changeover takes place, is shown. To make a change, you have to press the ESC
button for 5 seconds. The cursor jumps to the input eld and with pressing the OK button, the eld is rea-
dy for input. To change values and to change elds, it has to be navigated with the cursor. The modi ed
value must be con rmed with OK. Leaving from the input function is performed by pressing the ESC key.
Thus, the inputs are activated.
Function
On/O
switchover
time
8.8

Temperature stage function

With this image, the parameters of the temperature-dependent switch and the release are de ned. By
Function On / O this switching can be enabled / disabled. At higher or lower temperature, the second
indoor unit is connected or disconnected. The actual temperature value is also displayed. The procedure
to carry out changes, has been described in section 8.7.
Function
On/O
ON and OFF
ON:
OFF:
Temperature at which the unit 2 is turned on
Temperature at which the unit 2 is turned o
Hours
Remaining
time
Current
temperature
Setpoints
TOSHIBA I 17