Table of Contents
Advertisement
6
model no. 040-1193-8
Loosen the two adjustable hubs (B) by rotating
2
the two knobs
(C) counterclockwise. Separate the
two halves of each hub (B) and pull the rack arms
upwards.
Position the bike carrier so that the upper support
3
legs (D) rest on the top of the vehicle's trunk. Adjust the
angle of the upper support leg so that the end of the
rack arms (A) are slightly tilted inwards, towards the
vehicle.
After setting the position, tighten the adjustable
4
hubs (B) by rotating the knobs (C) clockwise. Ensure
the hub teeth are fully engaged.
WARNING:
Be cautious while adjusting the position of upper support leg, as it may
touch the rear glass of the vehicle.
CAUTION:
To avoid damage to the vehicle, ensure the lower support leg does not
rest on the rear bumper of the vehicle.
B
C
A
D
B
C
Insert the hooks of the two upper straps (F) into the
5
slots at the leading edge of the trunk or hatch lid of
the vehicle. Make sure the rack arms (A) are
positioned at an angle of about 15º with respect to
the ground. Tighten the upper straps until the bike
carrier holds its position.
SEE 5.1,.2,.3,.4,.5 FOR SUV, CUV OR
MINIVAN WITH A REAR VISOR!
Insert the hooks of the two side straps (G) into the
6
body gap on the outer edge of the trunk, hatch or
rear door. Make sure the side straps are at an angle
of 90° from the outer edge of the trunk.
Slide the hooks along the body gap until the strap
is taut at the shortest distance. Tighten the strap in
place.
CAUTION:
Make sure all the strap hooks are attached to the metal frame of
•
the trunk and not on the fiberglass, plastic or rear glass of the vehicle
Be sure that the straps do not rub against any sharp objects that could
•
cut or damage them.
F
F
A
G
G
7
Advertisement
Table of Contents
