Inst R Uction - Electrolux Zanussi ZWF 12280 W User Manual

Installation Instructions
Unpacking
All trans it bolts and packing must be removed
before using the appl i ance.
You are advised to keep all trans it devices so
that they can be refitted if the machine ever
has to be transported again.
1. After removing all the packaging, carefully
lay machine on it's back to remove the
polystyrene base from the bottom.
2. Remove the power supply cable and the
draining hose from the hose holders on the
rear of the appliance.
3. With a suitable spanner unscrew and
remove the centra l
rear bolt A.
4. Unscrew and remove the two large rear
bolts Band the six smaller bolts C.
26
5. Remove the bracket D, refit the six smaller
bolts C and slide out the relevant plast i c
spacer E.
tJ
6. Open the portho le, take out the inlet hose
from the drum and remove the polystyrene
block fitted with the adhesive tape on the
door seal.
7. Fill the smaller upper hole and the two large
ones with the corresponding plastic plug
caps suppl ied in the bag containing the
instruct ion booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circu lation around the machine is
not impeded by carpets , rugs etc. Check that
the machine does not touch the wall or other
kitchen units. Level the washing machine by
raising or lower i ng the feet. The feet may be
tight to ad just as they incorporate a self locking
nut, but the machine MUST be leve l and
stab le.
If necessary , check the sett i ng with a spirit
level.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration , noise and
displacement of the machine during
operation.Never place cardboard , wood or
similar mater i als under the machine to
compensate for any unevenness in the floor.