Fcc Class A Declaration Of Conformity; Environmental Protection - Fujitsu PRIMEHPC FX700 Upgrade And Maintenance Manual

Chapter 2 Important Information
2.7 Environmental Protection
frequency interference, in which case the user will be required to correct the interference at the user's
own expense.
2.6.2

FCC Class A Declaration of Conformity

The device may be marked with an FCC declaration, which would apply to the equipment covered in this
document unless otherwise specified herein. The declaration for other products will appear in the
accompanying documentation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules, and meets all requirements of the Canadian Interference-
Causing Equipment Standard (ICES-003) for digital apparatus. These regulations are designed to
provide reasonable protection against radio interference when the equipment is operated in a
residential installation. This product generates, uses, and can radiate radio frequency energy and, if
not installed and used in strict accordance with the instructions, may cause harmful interference to
radio communications. However, there is no warranty that interference will not occur in the conditions
at a particular installation. If the product causes harmful interference to radio or television reception
(which can be confirmed by switching the equipment on and off), the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit separate from that connected to the receiver.
- Consult a reseller or experienced radio/TV technician for support.
Fujitsu is not responsible for any radio or television interference caused by unauthorized modification
of this equipment or the substitution or attachment of connecting cables and equipment other than
those specified by Fujitsu. The user shall be responsible for correcting the interference caused by
such unauthorized modification, substitution, or attachment.
The use of shielded I/O cables is required when connecting the equipment to any optional peripheral
or host device. Failure to use shielded I/O cables may violate FCC and ICES regulations.
2.7

Environmental Protection

Environmentally-Friendly Product Design and Development
This product has been designed in accordance with the Fujitsu standard for "environmentally friendly
product design and development." This means that key factors such as durability, selection and labeling of
materials, emissions, packaging, and ease of dismantling and recycling have been taken into account.
This saves resources and thus reduces the harm done to the environment.
Energy-Saving Information
Devices that do not need to be constantly switched on should be switched off until they are needed as well
as during long breaks and after completion of work.
7 C120-0090-04EN