Electro-Voice X-Line X1i User Manual page 8

8 en | System overview X-Line Advance Install
X1i Passive line array elements
Each X1i-212 full-range element consists of one SMX2121 12-inch (304.8 mm) LF driver
coupled to a MBH (Mid Band Hydra), and two ND2R 2-inch (50.8 mm) titanium diaphragm HF
drivers. Each HF driver is mounted on a Wavefront-shaping Circular Hydra (WCH) planar-wave.
Each X1i element is designed in a two-way configuration, with either 90° or 120° horizontal
coverage pattern, and 10° vertical coverage pattern. X1i elements have an integrated passive
crossover and EQ network, which allows multiple elements to be driven on a single amplifier
channel. The enclosure is trapezoidal in the vertical plane with a 10° total included angle. X1i
is available in indoor and fully weatherized configurations, as well as white and black colors.
Grids and rigging kits are available to suspend each element in a variety of array
configurations, and eight M10 hard points are built into the product to suspend the array from
third-party structural frames.
X2i Biamp line array elements
Each X2i-212 full-range element consists of one DVN3125 12-inch (304.8 mm) LF driver
coupled to a MBH, and two ND6A 3-inch (76.2 mm) titanium diaphragm HF drivers. Each HF
driver is mounted on a Pin Diffraction Hydra (PDH) planar-wave generator. Each X2i element is
designed in a two-way configuration, with either 90° or 120° horizontal coverage pattern, and
10° vertical coverage pattern. X2i can be driven in biamp mode only. The enclosure is
trapezoidal in the vertical plane with a 10° total included angle. X2i is available in indoor and
fully weatherized configurations, as well as white and black colors. Grids and rigging kits are
available to suspend each element in a variety of array configurations, and eight M10 hard
points are built into the product to suspend the array from third-party structural frames.
X12i-128 Subwoofer system
X12i-128 is a high output dual-18-inch (457.2 mm) subwoofer element designed for use in
large subwoofer arrays. The X12i-128 subwoofer includes two high output DVF4180 woofers
designed specifically for subwoofer applications, providing reliable low-frequency
performance at high SPL levels. Subwoofer elements do not have internal passive crossovers
and require an active crossover and dedicated amplifier channel(s) for proper operation. The
X12i-128 is available in an indoor version that can be suspended or ground stacked, as well as
a fully weatherized version that can be suspended. Each variant is also available in white or
black finish.
X12i-GRID and X12i-RIGKIT line array rigging system
The X12i-GRID and X12i-RIGKIT are accessories that can suspend up to twelve X1i or X2i
elements. The grid connects to the top element in the array and is suspended from the venue.
At least one grid is required at the top of the array. A second grid may be used at the bottom
of the array to create a pullback point to the venue. The rigging kit is used to suspend each
element in the array to the element above, or to the grid. Use one rigging kit for each element
in the loudspeaker array. The X12i-GRID and X12i-RIGKIT use aluminum plates and stainless
steel hardware to ensure the rigging components will not corrode over time in direct exposure
environments.
2019.10 | V01 | F01U361103 User manual Bosch Security Systems B.V.