Electro-Voice X-Line X1i User Manual page 17

X-Line Advance Install
Notice!
These are general guidelines only. Always use PREVIEW to determine if a particular array can
be used with the rigging kits and grid.
Warning!
PREVIEW Loudspeaker Software MUST be used to design the array. PREVIEW will state
!
whether the array configuration is valid for use with the X12i-RIGKIT and X12i-GRID
accessories. Follow all warnings within the software. Failure to design the array properly may
result in serious injury or death.
Notice!
Electro-Voice has experienced and knowledgeable application engineers willing to assist with
any design related questions. Contact information for technical support is located at
www.electrovoice.com
Bosch Security Systems B.V.
1. Use PREVIEW Loudspeaker Software to
design the array.
PREVIEW will determine whether the
array can be suspended with the
optional grid and rigging kits for your
particular application, with the safety
factor that you determine based on local
laws and regulations.
2. If PREVIEW states the array
configuration is valid, the optional grid
and rigging kit may be used to suspend
the array. Follow the directions in the X-
Line Advance Install Rigging manual,
available at www.electrovoice.com
3. If PREVIEW determines that the desired
array configuration is not valid or not
possible, a custom rigging solution is
needed. Please see section Custom frame
design considerations, page 27
User manual
Designing an X1i or X2i array | en
2019.10 | V01 | F01U361103
17