Solutions to Sound Problems
If there is no sound when you expect it or the volume is too low or high, try the following solutions:
• Adjust the projector's volume settings.
• Press the
temporarily stopped.
• Press the
source, if necessary.
• Check your computer or video source to make sure the volume is turned up and the audio output is set
for the correct source.
• Check the audio cable connections between the projector and your video source.
• If you do not hear sound from an HDMI source, set the connected device to PCM output.
• Make sure any connected audio cables are labeled "No Resistance."
• If you are using a Mac and you do not hear sound from an HDMI source, make sure your Mac
supports audio through the HDMI port. If not, you need to connect an audio cable directly to your
speaker system.
• If you connected an audio device to the projector's Audio Out port, the internal speaker is disabled.
However, you can still control the volume level via the projector's control panel or remote control.
• If you turn the projector on immediately after turning it off, the cooling fans may run at high speed
momentarily and cause an unexpected noise. This is normal.
Parent topic:
Related concepts
Projector Connections
Related tasks
Controlling the Volume with the Volume Buttons
Shutting Off the Picture and Sound Temporarily
Solutions to Bluetooth Audio Problems
If you cannot connect to a Bluetooth audio device, try the following solutions:
• Make sure the Bluetooth Audio setting is turned on in the Settings menu. If you are using the
projector's speaker or headphones, turn this setting off.
• Select Search Bluetooth Device in the Settings menu when you pair a Bluetooth audio device for
the first time or change to another Bluetooth audio device.
A/V mute button on the projector remote control to resume video and audio if they were
Source button on the projector or the remote control to switch to the correct input
Solving Image or Sound Problems
108