Operation; Lock Adjustment; Light Bulb - XO Appliance XOA30 Instructions Manual

2.Reinstall the wiring box cover.
3.Plug back the small connector inside the hood.
4.Reinstall the bottom plate, make sure both grease guides are aligned with the
holes, install the grease pan.
5.Using long nose pliers. Pull out each of grease guides (A), then set them in
such a way their flange slightly protrudes above the bottom of surface (B).

LIGHT BULB

This range hood may require two halogen bulbs (Type JCD, 12V, 20W Max, G-4 Base)
WARNING: Always switch off the electrical supply before carrying out any operation on
the appliance.
To change bulbs:
1.Kick off the halogen bulb cover by using the flat screw driver.
2.Remove the bulb by pulling sideward (DO NOT ROTATE).
3.Replace with Type JCD, 12V, 20W Max, G-4 Base halogen bulb. Do not touch
replacement bulb with bare hands!
11
CAUTION:
1.THE SURFACE, THE COVER OF THE HALOGEN BULBS MAY BE HOT. TAKE CARE WHEN
TAKING THE REPLACEMENT.
2.BULBS MAY BE HOT. TAKE CARE WHEN TAKING THE REPLACEMENT.

OPERATION

The hood is operated using electronic switch on the front panel.
ELECTRONIC SWITCH
1 –TIMER DELAY OFF SWITCH
2 – LAMP SWITCH
3 - DISPLAY
4 – FAN SPEED SWITCH
5 - ON/OFF SWITCH

LOCK ADJUSTMENT

When using this hood for the first time, or after a power failure, the display flashes regularly. To
stop flashing, press on/off key for more than 5 seconds, the hood will be set to time
setting mode. By pressing lamp key or fan speed key to change time setting, each single
press or keep keys pressing can changes the time by 1 or 3 either up or down. Press the
on/off key for confirmation when the right time appears.
1.The timer delay off switch, user can adjust the time 3-6-9-12-15-0 minutes by
pressing this button in turn, if no action occurs within 3 seconds, the countdown will
start automatically. The hood will be off when the countdown ends.
2.The lamp switch button,
Controls the lamp on and off;
Change the time down in time setting mode.
3.Display, shows the hood operation status and setting.
4.Fan speed button (six speeds)
Controls the fan speed;
Change the time up in time setting mode.
5.On/off switch button
Controls the hood on and off if pressing less than 5 seconds.
Entry to time setting mode if pressing more than 5 seconds.
12