ANDELI MIG-270TPL Owner's Manual page 7

TYPE
Power supply voltage (V)
Input current (A)
Power supply capacity (KVA)
Current adjustment range (A)
Output voltage (V)
Rated output current (A)
Rated output voltage (V)
Rated duty cycle (%)
Power factor
Efficiency (%)
Wire feeder type
Post-flow time (s)
Welding wire diameter (mm)
Machine size (mm)
Machine weight (kg)
Plate thickness (mm)
Insulation class
Protection class
Note: The welding duty cycle is the percentage of actual continuous welding time that can occur in a ten-minute cycle.
For example: 15% at 200amps- this means the welder can weld continuously at 200 amps for 1.5 minutes and then the
unit will need to be rested for 8.5 minutes.
The duty cycle can be affected by the environment in which the welder is used. In areas with temperatures exceeding
40℃, the duty cycle will be less than stated. In areas less than 40 ℃, higher duty cycles have been obtained.
All tests on duty cycles have been carried out at 40℃ with a 50%. So in practical working conditions the duty cycles
will be much greater than those stated above.
MIG-270TPL
single-phase
220V15%
35
8
50～200
15～24
200
24
30
0.75
85
External/Internal
拉丝
1
分体
0.6/0.8/1.0
480×310×430
15
≥0.8
H
IP21S
6