Advertisement
3. SPECIFICATION
Model No .................................................................. PFC301
Lifting Capacity Position 1 .......................................... 3000kg
Lifting Capacity Position 2 .......................................... 2500kg
Lifting Capacity Position 3 .......................................... 2300kg
Lifting Capacity Position 4 .......................................... 2000kg
Max. Lift Ht. at Max. Jib Ext. Position 1 .................... 2720mm
Max. Lift Ht. at Max. Jib Ext. Position 2 .................... 2850mm
Max. Lift Ht. at Max. Jib Ext. Position 3 .................... 2950mm
Max. Lift Ht. at Max. Jib Ext. Position 4 .................... 3050mm
Length of Jib Position 1 ............................................ 1430mm
Length of Jib Position 2 ............................................ 1580mm
Length of Jib Position 3 ............................................ 1730mm
Length of Jib Position 4 ............................................ 1870mm
Height Jib Down ....................................................... 1930mm
Length ...................................................................... 2400mm
Rear Width ............................................................... 1275mm
Width Inside Front Frame ......................................... 1100mm
Width Front Frame ................................................... 1300mm
Height of Frame ......................................................... 265mm
Weight .......................................................................... 299kg
Oil Capacity ................................................................ 1300ml
4. ASSEMBLY AND OPERATION
WARNING! Due to heavy elements, it is essential to carry out the following assembly processes with the help of other people.
‰
4.1.
Wedge the wheels to avoid the movement of the crane.
4.2.
Fixed cranes are assembled by positioning the column (10) on the legs (9), securing it with the screws provided.
4.3.
The arm (11) is then assembled with its slide (12) to the column and finally to the hydraulic unit (15) on a support located on the
column. The operation is completed with the securing of the central piston to the arm (11) using a rivet and two elastic rings.
4.4.
Before using the crane, it is necessary to purge air from the valve system of the hydraulic unit by turning the release valve (6) anti-
clockwise and,whilst held in this position, pumping the crane several times. Close the release valve(6)clockwise until is fully closed.
4.5.
To lift the load, activate the lever (2). If lifting an engine, secure it at the points recommended by the manufacturer.
4.6.
To lower the load, turn the release valve (6) very slowly anti-clockwise. Our cranes are fitted with a safety device that only permits
the load to be lowered smoothly by automatically controlling the speed at a rate dependant upon the size of the load ( L.C.S.).
4.7.
Following use of the crane, the piston of the hydraulic unit and the jib should be fully retracted.
4.8.
4.9.
© Jack Sealey Limited
Original Language Version
PFC301 Issue: 2(F) - 31/10/18
Advertisement
