Advertisement
Z-Stick 7 user guide.
Z-Stick 7 was developed to control actuators and sensors in a Z-Wave Plus Network as a self-
powered Z-Wave® USB Adapter. It is powered by Series 700 and Gen7 technology utilizing
SmartStart native integration and S2 security.
Important safety information.
Please read this and other device guides carefully. Failure to follow the recommendations set
forth by Aeotec Limited may be dangerous or cause a violation of the law. The manufacturer,
importer, distributor, and/or reseller will not be held responsible for any loss or damage resulting
from not following any instructions in this guide or in other materials.
Keep product and batteries away from open flames and extreme heat. Avoid direct sun light or
heat exposure. Improper battery use may damage the product.
Z-Stick 7 is intended for indoor use in dry locations only. Do not use in damp, moist, and / or wet
locations.
Advertisement
Table of Contents
Related Manuals for Aeotec Z-Stick 7
Summary of Contents for Aeotec Z-Stick 7
- Page 1 Keep product and batteries away from open flames and extreme heat. Avoid direct sun light or heat exposure. Improper battery use may damage the product. Z-Stick 7 is intended for indoor use in dry locations only. Do not use in damp, moist, and / or wet locations.
- Page 2 Quick start. The following will step you through using Z-Stick 7 when it is attached to a host controller (PC) as a primary controller. Please make sure the host controller is pre-installed; this includes any drivers that the corresponding OS may need. In most cases, the host controller automatically installs the required USB drivers.
- Page 3 Current compatible software and setup guides. In order for the Z-Stick 7 to be used with your software of choice, it must support Z-Wave bridge library. Below is a list of all the known software that are compatible to Z-Stick 7 and how to set them up.
Need help?
Do you have a question about the Z-Stick 7 and is the answer not in the manual?
Questions and answers