Table of Contents
Advertisement
4.4 TRANSMIT TIME - OUT TIMER (TOT)
While the PTT switch is held down, transmission time is limited to 5 minutes. This prevents
prolonged unintentional transmissions. About 10 seconds before automatic transmitter
shutdown, a warning beep is sounds from speaker. The transceiver automatically switches
to the receiving mode, even if the PTT switch is held down. Before transmitting again, the
PTT switch must first be released and press again. This time-out timer (TOT) prevents a
continuous transmission that would result from an accidentally stuck PTT switch.
4.5 USA, CANADIAN, AND INTERNATIONAL MODES
1.
To change the mode of the transceiver, Held down the 16/9 key and press the WX key.
The mode changes from USA, to International, to Canadian with each press.
2.
"USA" appear on the LCD for the USA mode, "CAN" appears for Canadian mode, and
"INTL" appears in International mode.
3.
Refer to marine channel charts in OWNER'S MANUAL SUPPLEMENT for allocated
channels in each mode.
4.6 NOAA WEATHER CHANNELS
1.
To receive a weather channel, press the WX key. The transceiver changes to the
weather channel mode.
2.
Press the [UP] or [DOWN] key to change to other weather channels.
3.
To exit from the weather channels, press the WX key. The transceiver recalls the
previous non-weather channel.
4.7 SCAN
1.
Select the desired channel to be scanned using the [UP] or [DOWN] key.
2.
Press the MEM key to store the channel into the transceiver's memory. "MEM" is
displayed on the LCD.
3.
Repeat steps 1 and 2 for all the channels to be scanned.
4.
To delete a channel from the transceiver's scan memory, press the MEM key again
while the memorized channel is displayed. "MEM" disappears.
5.
All channels programmed remain in the transceiver's scan memory even if the power is
turned
off.
MICROPROCESSOR" to clear all the transceiver's scan memory.
6.
Adjust the SQUELCH CONTROL knob until background noise is eliminated.
7.
To start scan, press the SCAN key. The scan proceeds from the lowest to the highest
programmed channel number and stops on channels when a transmission is received.
8.
To stop the scan, press the SCAN key.
4.8 PRIORITY SCAN
1.
The following channels can be set as the priority channel; 16, 09, and Preset Channels
1 through 5 (Preset Channel described section 4.14). To set the priority channel, hold
down the 16/9 key and press the MEM key. The channel changes from 16 to 09 to
Preset 1 to Preset 2 to Preset 3 to Preset 4 to Preset 5 channel with each press of the
MEM key. The displayed channel is set to the priority channel.
2.
For priority scanning, hold down the SCAN key at least 1 second during normal
scanning. Scanning will proceed between the memorized channels and the priority
channel. The priority channel will be scanned after each programmed channel.
3.
For example, channels 06, 07, 08 are memorized in the transceiver's memory, Priority
scanning will proceed in the following sequence:
[CH06]
[Priority Channel]
Channel]
[CH06]
4.
Even when the transceiver stops and listens to the signal of a programmed channel, the
transceiver will dual watch between this channel and the priority channel.
See
section
"4.17
[CH07]
[Priority Channel] .........
RESETTING
[Priority Channel]
7/14
FCC ID: K6630083220
IC ID: 511B-30083220
Operating Manual
THE
TRANSCEIVER'S
[CH08]
[Priority
Vertex Standard Co., Ltd.
Advertisement
Table of Contents
