RGMT NAVIGATOR Instruction Manual

INSTRUCTION MANUAL
BEDIENUNGSANLEITUNG
Vol. 1.06 EN DE
HOW TO SET THE DATE AND TIME
*Before setting the time, check that the chronograph
measurement is stopped.
1. Pull out the crown to the position [1]-(1st click).
2. Turn the crown clockwise until the preview day's
date appears.
3. Pull out the crown to the position [2]-(2nd
click). when the second hand is at the 12 o'clock
position. It will stop on the spot. Set the hands to
the desired time of the day (make sure AM/PM is
set correctly) by turning the crown.
* When the crown is at the position [2]-(2nd click),
do not press any pusher. Otherwise the
chronograph hands will move.
4. Push the crown back in the position [0] in
accordance with a time signal.
SPLIT TIME
MEASUREMENT
S PL IT
STA R T SPL I T
REL E ASE
R ES ET S TOP
Measurement and release of split time can be
repeated as many times as necessary by pressing
the button B.
CHRONOGRAPH
WATCH
For more details on operating this timepiece
please refer to the enclosed booklet or visit :
IM.RGMT.CO
* Do not set the date between 9:00 P.M. and 3:00
A.M. , otherwise the day may not change properly.
If it is necessary to set the date during the time
period, first change the time to any time outside
it, set the date and then reset the correct time.
1
WATER RESISTANCE
Note that the water resistance chart serves only as a
guide (please refer to the water resistance chart on the
next page). Actual water resistance may vary depending
on a number of factors including water temperature,
water salinity, and use under water.
The water resistance of your timepiece may eventually
be compromised over time with general wear and tear
and use of your timepiece under adverse conditions.
Always remember to employ the screw down crown if
available to maintain the water resistance of your
timepiece. Warranty may be voided if the screw down
crown has not been properly employed.
Note that you should never wear your watch in a jacuzzi
or steam room where steam may enter the case despite
the water tight seals used to protect your watch. This
may cause condensation inside your watch which may
effect and damage the inner workings of your watch.
5
HOUR HAND
CHRONOGRAPH
60 MINUTE
HAND
60 24
20 4
45 15
16 8
30 12
60
50 10
40 20
30
SECOND HAND
CHRONOGRAPH
SECOND HAND
(MOV'T VD53)
Remarks :
The measurement time indicated by the stopwatch
hands move independently of the center hands.
STOPWATCH FUNCTION
• The measurement of time is indicated by the
stopwatch hands that move independently of the
center hands and 24-hour hand.
• The stopwatch can measure up to 60 minutes.
STANDARD MEASUREMENT
START STOP
2
WATER RESISTANCE
CHART
SP L A SH /
SH OWE R ING
SW IM M IN G/
BAT H IN G
B RIE F SW IM M IN G/
WAT E R SPOR TS
P R OLON GE D
SW IM M IN G/
F RE E D IVIN G
SC UBA
D IVIN G
P R OF E SSION AL
D E E P SE A D IVING
MINUTE HAND
24 HOUR
HAND
PUSH
BUTTON A
CROWN
0 1 2
PUSH
BUTTON B
DATE
ACCUMULATED ELAPSED TIME
MEASUREMENT
START STOP
RE SET
RESET
Restart and stop of the stopwatch can be repeated
by pressing the button A.
3
30M/ 50M/ 100M/
3ATM 5ATM 10ATM
RE START
STOP
4
150M/ 200M/
15ATM 20ATM