Advertisement
F-84F Thunderstreak 90mm edf
Now finish with... Vallejo, humbrol or we used cheap spray cans... take care for the vacuumformings as
some paints will not hold as good, or worse will dissolve or make it brittle, use a primer
Place wing, place canopy, check CG, Go Fly.
Have you found an error in the drawing or parts or instructions, just mail us at
info@rbckits.com
I am sure we can find a solution for your build.
Some tips:
Do not make it tail heavy, and Do not make it nose heavy
Flying:
The F84 easy lifts off with a bit of flap (10-15mm)and is easy to fly and is fast, landing: plan it in and
land it as usual a bit of flap (10-25mm) a bit of throttle is ok , landing can be slow the F84 glides very
well with wheels in in case of ....
A 8S 5000 battery is powerful enough,
Make Centre of gravity as on the drawing we used the forward part of the range this worked out very
well, in reversed flight it need down elevator so you might want to get back a little , also you need to
adjust your elevator throws with a more rearward CG
Throws of the rudders etc., we like them big, we steer just around the centre of the sticks but it might
be too much for you so always, make them large and have a dual rate button in your fingers, to small
throws is most of the time problems, to large... it is in your fingers
If you need additional pictures, check the disk or just ask.
Have a good build and flight with the F-84F
Materials you might need:
Material you need for building:
1,5mm steering wire 1mtr
0,8mm steering wire 1mtr front steering and hatch
CA hinges 12x
Front Gear door hinges 4x
Fastener 2,9x13 12x for retracts
Fastener 2,2x9 10x front retract doors
Fastener 2,2x6 8x main retract doors
Brass tube 5x30 4x main retract saddles
Brass tube 5x30/40 2x main retract legs fill
Steel wire 4mm 1mtr retract legs bend yourself
M4 rings 6x wheel stop soldering
Kwiklinks 2mm 3x front steering and flaps
Rudder horns 6x
Pagina 32
Advertisement
