ADTRAN 850 Installation And Operation Manual page 8

FCC regulations require that the following
information be provided in this manual to the
customer:
1. This equipment complies with Part 68 of the FCC
rules. The required label is affixed to the bottom of
the chassis.
2. An FCC-compliant telephone cord and modular plug
is provided with this equipment. This equipment is
designed to be connected to the telephone network
or premises wiring using a compatible modular jack
which is Part 68-compliant. See Chapter 2, Installa-
tion, for details.
3. If your telephone equipment (TA 850) causes harm to
the telephone network, the telephone company may
discontinue your service temporarily. If possible,
they will notify you in advance. But if advance notice
isn't practical, you will be notified as soon as possi-
ble. You will be advised of your right to file a com-
plaint with the FCC.
4. Your telephone company may make changes in its
facilities, equipment, operations, or procedures that
could affect the proper operation of your equipment.
If they do, you will be given advance notice to give
you an opportunity to maintain uninterrupted service.
5. If you experience trouble with this equipment (TA 850),
please contact ADTRAN at (256) 963-8000 for repair/
warranty information. The telephone company may
ask you to disconnect this equipment from the network
until the problem has been corrected or until you are
sure the equipment is not malfunctioning.
6. This unit contains no user-serviceable parts.
7. The following information may be required when
applying to your local telephone company for leased
line facilities.
8
For a T1 Port:
Service Type
1.544 Mbps - SF
1.544 Mbps - SF and
B8ZS
1.544 Mbps - ESF
1.544 Mbps - ESF
and B8ZS
ISDN
For an FT1 Port:
Service Type
1.544 Mbps - SF
1.544 Mbps - SF and B8ZS
1.544 Mbps - ESF
1.544 Mbps - ESF and B8ZS
ISDN
When connecting FT1 port towards the network, a
suitable crossover cable is required.
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may
cause harmful interference to radio frequencies. Opera-
tion of this equipment in a residential area is likely to
cause harmful interference in which case the user will
be required to correct the interference at his own ex-
pense.
Shielded cables must be used with this unit to ensure
compliance with Class A FCC limits.
Change or modifications to this unit not expressly
approved by the party responsible for compliance
could void the user's authority to operate the
equipment.
Issue 2, August 2001
REN/ FIC
SOC
6.0N 04DU9-BN
6.0N 04DU9-DN
6.0N 04DU9-1KN
6.0N 04DU9-1SN
6.0N 04DU9-ISN
REN/ FIC
SOC
6.0N 04DU9-BN
6.0N 04DU9-DN
6.0N 04DU9-1KN
6.0N 04DU9-1SN
6.0N 04DU9-ISN
NOTE
WARNING
61200373L1-5B
USOC
RJ-48C
RJ-48C
RJ-48C
RJ-48C
RJ-48C