9. Blade cutting adjustment
Remove sparkplugcap before adjusting blade.
To adjust he blade tighten the 2 nuts on the blade
shield.
To check for correct adjustment, insert a piece of
paper between the blade and the cutting cylinder.
When the cutting cylinder is turned by hand the
paper should be cut cleanly.
Blade is already adjusted from the factory.
Only adjust if necessary. Use the included tool for
this purpose.
10. Start/stop
Check the level of oil and gasoline. Tank if
necessary.
Press the carburetor pump 5 times(if is a clear plastic
ball). The pump is places below the choke.
If the engine is cold, the choke is be set to ON.
1. Set the switch on "ON"
2. Press the Safety Release Button and hold the
Operation Lever in half way.
3. Pull the start cord until the engine starts.
4. Activate the cutting cylinder by pressing the
Safety Release Button and the Operate Lever.
When the engine is warm (after approx. 1 min.)
the choke should be turned OFF.
Stop by releasing the handle.
And set the switch to "OFF"
www.texas.dk
17