Related Manuals for Reefe RPC32E
Summary of Contents for Reefe RPC32E
- Page 1 AUTOMATIC PRESSURE CONTROLLER TECHNICAL DATA MODEL: RPC32E CODE: 20876 www.reefe.com.au...
- Page 2 CONTROL PANEL & DIMENSIONS Power Indicator ‘Low Water’ Loss DIMENSIONS of Prime Indicator (MM) MODEL Power ON|OFF indictator Manual reset button RPC32E 1” after a run dry event PRESSURE LOSS DATA MODEL L/MIN RPC32E PRESSURE LOSS 0.25 Flow L/Min www.reefe.com.au...
- Page 3 ELECTRIC CONNECTION (Fig. 2) Check the power supply to be ~220 ±10% Vac, dismount the cover 1 of the electronic circuit, and make the connections as per diagram on plate 2. The RPC32E can be used with a single-phase pump with electrical input greater than 16 A.). In this case the electrical connections must be made as shown in the diagram, fig.3 WARNING Bad connections may spoil the electronic circuit.
- Page 4 (LOW WATER) will be on.Check the sealing of the connections and O-ring of the aspiration conduct. 3. The pump starts and stops repeatedly: a. Small leak in some point of the installation: Verify possible tap or WC tank leaks and repair them. www.reefe.com.au P: 1800 807 604 Ascento Group Australia AI.062020...
Need help?
Do you have a question about the RPC32E and is the answer not in the manual?
Questions and answers