Terminals Crimping Instructions; Assembly Procedure - WEG CVW-300 Assembling Manual

Signal Conectors Kit KCS-300
For any detailed information about the pin functions,
please refer to the CVW300 user manual.
3 TERMINALS CRIMPING
INSTRUCTIONS
Wire Sizes / Crimping Tool Recommendations
5.1 mm
Recommended crimping tool: TE 58529-1.
The correct wire crimping is shown below:
Wire strand ends must
be visible in this area
Wire strands and insulation shall
0.25 mm max-0.13 mm
min front bellmouth

4 ASSEMBLY PROCEDURE

Before assembling, the wedge lock must be in the open,
or as-shipped, position.
Contact
(partially inserted)
Diaphragm
The plug must be assembled as it follows:
1. To inser t a contact, push it straight into the
appropriate circuit cavity as far as it will go.
2. Pull back into the contact wire with a force of 4.45 to
6 | CVW300
0.5 ... 1.4 mm
both be visible
Wire seal
Mating seal
/ 20 ... 16 AWG
2
Wire barrel shall be closed
at seam with no strands
protruding of showing
Ends of insulation
barrel must be
wrapped around
wire insulation
leaving no sharp
points to damage
rubber wire seal
0.13-0.75 mm
rear bellmouth
0.25 mm max cutoff tab
Retention
fingers
Wedge lock (shown
in open position)