Chapter-9: Failure Codes And What To Do İn Case Of Failure - Sharp QW-D21I492X-EU User Manual

CHAPTER -9: FAILURE CODES AND WHAT TO DO IN CASE OF
FAILURE
ERROR CODE
P1 P2 P3
If one of the program monitor lights is on and Start/Pause light is on and off,
Your machine's door is open, shut the door.
If the programme won't start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by pressing the Power On / Off button.
• Be sure that the water inlet filter and lights the machine filters are not clogged.
If the "Wash/Dry" and "End" keep flashing
• The water overflow alarm is active
• Turn off your tap and contact the Sharp helpdesk.
If the control lights won't go out after a wash operation
Check if the Power On/Off button is released.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
If water is left inside the machine at the end of the programme
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The programme is not finished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
If shaking and hitting noises are heard during a wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.
ERROR
DESCRIPTION
P4 P5
Inadequate water
supply
Continuous
water input
The waste water in the
machine cannot be
discharged.
Heater error
Alarm is active against
water overflow
Faulty electronic card
Overheating error
(temperature in the
machine is
too high)
Faulty heater sensor
CONTROL
• Make sure the water input tap is totally
open and that there is no water cut.
• Close the water input tap, separate the
water input hose from the tap and clean the
filter at the connection end of the hose.
• Restart your machine, contact for service if
the error resumes.
• Turn off the tap.
• Contact for service.
• Water discharge hose is clogged.
• The filters of your machine might be
clogged.
• Power off-on your machine and activate the
program cancellation command.
• If the error continues, contact for service.
• Contact for service.
• Power off your machine and turn off close
the tap.
• Contact for service.
• Contact for service.
• Contact for service.
• Contact for service.
EN-22