Pyronix ENFORCER SMOKE-WE Manual page 3

The Enforcer wireless photoelectric smoke alarm is designed to sense smoke that comes into the
alarm chamber. It does not sense gas, heat, or flame. This smoke alarm is designed to give early
warning of developing fires by giving off the alarm sounds from its built-in alarm piezo. It can
provide precious time for you and your family to escape before a fire spreads. However, the
smoke alarm makes such pre-warning of fire accident possible, only if the smoke alarm is
located, installed, and maintained properly as described in this manual.
WARNING: This alarm is not meant to be used in non-residential buildings. Warehouses, indus-
trial or commercial buildings, and special purpose non-residential buildings require special fire
detection and alarm systems. This smoke alarm alone is not a suitable substitute for complete
fire detection systems for places where many people live or work, such as hotels or motels. The
same is true of dormitories, hospitals, nursing homes or group homes of any kind, even if they
were once single family homes. Please refer NFPA 101, the Life Safety Code, NFPA71, 72A, 72B,
72C, 72D, and 72E for smoke alarm requirements for fire protection in buildings not defined as
"households".
WARNING: This smoke alarm will not alert people who are hard of hearing. It is strongly recom-
mended that the special-purpose smoke alarms, using lights or vibrating devices, should be
installed to alert occupants who are hard of hearing.
Learning the SMOKE-WE onto the Enforcer Control Panel
When you are ready to learn the device to the control panel receiving equipment, and when the
equipment is in the learn mode (see Enforcer Programming Manual) follow the procedure below.
1. Unclip the base of the smoke detector at the three points shown on Figure 1.
Note: Open the device very carefully so as not to damage any wiring.
2. Make sure the battery is installed correctly and the plastic wrapping removed.
3. Press and hold the Learn button until the LED flashes red and green, then release.
4. The device is correctly learnt when the Green LED flashes.
Introduction
Battery
compartment
Figure 1
Opening the smoke detector
1