Table of Contents
Advertisement
Available languages
Available languages
Practical recommendations:
Do not insert hot drinks, which are at room
temperature, inside.
Close the door quickly when it is used, this
ensures that there is no sudden change in the
interior temperature.
POWER FAILURE
Most power failures are corrected within a few
hours and should not affect the temperature of
your appliance if you minimize the number of
times the door is opened. If the power is going
to be off for a longer period of time, you need
to take the proper steps to protect your
contents.
ENERGY SAVING TIPS
The Wine cooler should be located in the
coolest area of the room, away from heat
producing appliances, and out of the direct
sunlight.
One characteristic of thermoelectric units is the
length of time it requires to recover from having
the door opened and shut frequently. It may be
necessary to wait longer for the temperature to
return to its former level once the door has
been opened for too long. This is normal for
this type of unit.
Cleaning
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Wash the inside surfaces with a warm water
and baking soda solution. The solution should
be about 2 tablespoons of baking soda to a
quart of water.
Wash the shelves with a mild detergent
solution.
Wring excess water out of the sponge or cloth
when cleaning area of the controls, or any
electrical parts.
Wash the outside cabinet with warm water and
mild liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
Anomalies and repair
Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
If any anomaly is detected, check the following
table to find the possible causes:
Anomalies
Causes
Wine cooler
Not plugged in.
does not
The circuit breaker tripped or
operate.
a blown fuse.
Control panel
Push the button
is locked
2-3 seconds to unlock the
control panel.
Wait for the second beep
sound.
Wine cooler
Check the temperature
isn't cold
control setting.
enough.
External environment may
require a higher setting.
The door is opened too often.
The door is not closed
completely.
The door gasket does not
seal properly.
The Wine cooler does not
have the correct clearances.
Abnormal voltage.
The light does
Not plugged in.
not work.
The circuit breaker tripped or
a blown fuse.
The light button is "OFF".
Vibrations.
Check to ensure that the
wine cooler is levelled.
The door will
The Wine cooler is not level.
not close
The door was not properly
properly.
installed.
The gasket is dirty.
The shelves are out of
position.
- This appliance is protected by restarting itself of
possible quick transients, in this case reestablish
the desired configuration of the device.
Characteristics:
Model
Category of the
appliance
Energy Efficiency
Class
Annual Energy
Consumption (AEc)
Capacity
Maximum working
for
PTWC-12
10
A
120 kWh/year
32 L (12 bottles)
32 ºC
Advertisement
Table of Contents
